[rbak-nsp] Subscriber pq QoS not applying

[Tanan Satayapiwat]

You should turn on debug aaa all instead as applying parameter is aaa job.

Let's see if debug aaa all tell you anything.

Tanan 

-----Original Message-----
From: jim at scusting.com [mailto:jim at scusting.com] 
Sent: Thursday, April 29, 2010 3:12 PM
To: Tanan Satayapiwat
Cc: redback-nsp at puck.nether.net
Subject: Subscriber pq QoS not applying

I'm trying to apply the pq QoS to a subscriber but it doesnt seem to apply for some reason.  Here is the config I have:

-------
qos policy testpq pq
 num-queues 4
 queue 0 rate 3250 burst 40000
 queue 1 rate 250 burst 40000
 queue 2 rate 250 burst 40000
 queue 3 rate 250 burst 40000

context test
 subscriber default
   qos policy queuing testpq
   rate circuit out 4000 burst 15000 excess-burst 15000
-------

But when check the users session I see 'not applied':

test-dynamic at domain.com
        qos-queuing-policy testpq (not applied from sub_default)

Why is it not applying this QoS profile?  Its obviously seeing it defined in the subscriber default but rejecting it for some reason.  I can apply a metering profile fine but not a pq one - am I missing something?
I enabled "debug qos all" but that didnt give me anything.

Thanks,

Jim.