[rbak-nsp] Multicast on SE800

[Jvuvant Y]

Hello Mickael

Thanks for the config.
this configuration is working well like any cisco or juniper router as the SE is configured as a router.
But I would like to provide Mcast on subscriber PPPoE session. So just by adding following command on your configuration, it seems not working for subscriber subs1 once connected.
Do i miss something or do i have to change approach?

Jacques 
....
!
interface ToDSL multibind
ip address 172.20.1.1/23
ip pool 172.20.1.0/23
pim sparse-mode passive
!
subscriber name subs1
password xxxx
ip address pool
!
port ethernet 14/1
encapsulation pppoe
bind authentication chap pap
!


Jacques
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/redback-nsp/attachments/20101111/f47a161b/attachment.html>