From: Scott Whyte <wwhyte@cisco.com>
To: cisco-nsp@iagnet.net <cisco-nsp@iagnet.net>
Date: Wednesday, March 25, 1998 12:38 PM
Subject: Re: [nsp] Router Reset problem
>Is it "copy sta ru" or "copy ru sta" you are doing, you have both listed
>below...
>
I use 'copy tftp sta' then 'copy sta ru'
Sorry for the confusion.
Mike
>
>On Wed, 25 Mar 1998, Michael Smith wrote:
>
>> Hello All:
>>
>> I have a 7505 that, upon issuing the following commands, reboots itself
with
>> a Bus error. I have a case open with TAC, but they have to hunt down a
>> particular programmer to decode the stac trace, and it may take several
>> days.
>>
>> Here it is:
>>
>> copy tftp start
>> copy start run
>>
>> I have about 100 PVC's on 7 serial ports and, upon issuing the copy ru
sta
>> portion, I get about 90 "PVC already defined" messages and then it just
>> stops and reboots.
>>
>> We used to do configs on the router and then offload them to the tftp
>> server, but I'm trying put all the configs under revision control, so I
>> would prefer this method.
>>
>> Any help would be greatly appreciated!
>>
>> Mike
>>
>> Michael K. Smith
>> Senior Network Administrator - Northwest Link
>> (800) 390-1270
>> http://www.nwlink.com
>> mksmith@nwlink.com
>>
>>
>
>-------------------------------------------------------------------
>Scott Whyte swhyte@cisco.com |Any opinions expressed herein are
>Network Supported Accounts (NSA) |mine and not cisco's...
>CCIE 3340 |
> | "Eschew Obfuscation"
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:15 EDT