[cisco-voip] Same Trunk on Both Side

[Ryan Ratliff]

I think what you'll need to do is set a dialed-number translation to prefix
some digit(s) on the inbound dial-peer.  Then use this prefix to route the
call out the specific outbound dial-peer on the other side, where you can
strip the prefix before sending the call out to the PBX.
 
This doc does basically the same thing except based on calling party.  It
can easily be adjust to use the calling port.
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_exampl
e09186a00801c0a88.shtml
 

-Ryan 

 

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ramiz Sardar
Sent: Friday, February 01, 2008 2:20 AM
To: cisco-voip
Subject: Re: [cisco-voip] Same Trunk on Both Side


Still Waiting.......


On Jan 31, 2008 9:04 PM, Ramiz Sardar <ramizchaudhary at gmail.com> wrote:


Friends,

I am currently working on voip setup. My topology you can see below:

PhoneA----- PBX 1----------(2 PRI)-------Router1-----------Router2------(2
PRI)---PBX2---------PhoneB

As you can see that Routers are connect with PBXs through 2 E1 PRIs. I want
to make configuration so that if a call come from first pri (trunk) on
Router 1, on Router2 it most go on first pri  (trunk) that is connect to
PBX2 and same for second pri. Means If i recieve call from PBX1 on port
1/0:15 then i could tag it some how and and Router 2 recieve that call, it
send it you its port 1/0:15 and same for second port 1/1:15 on both side.
Tell me the way how can i do that.

Waiting for positive immediate response..

Best Regards



-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080201/8f76b1e0/attachment-0001.html