[cisco-voip] PSAP sees Billing Telephone Number, not DID associated with phone

[Scott Voll]

NO. the reason this happens is that you have not purchased the PS-ALI
service.

With out the PS-ALI service it will default to your billing number.  Which
as an Address associated to it.

if you want your DID's to go out...... you have to have the PS-ALI service
and have setup the DID's to a location with the service.

If you're going to go that far........ I would look at CER or 911enable or
Redsky.

Otherwise....... as Cisco would say....... working as designed (by the
telcos)

Hope that helps.

Scott.

On Fri, Oct 30, 2009 at 1:49 PM, Lund, John C. <LUNDJC at uwec.edu> wrote:

>  Hi,
>
>
>
> We purchased a PRI (Cisco 2851 Gateway) from ATT, and while testing I find
> out the PSAP only sees the BTN when I make a test 911 call.  I called the
> ATT trouble line and they told me they never block the calling number and
> that it is configurable on each PBX.
>
>
>
> Are they correct and is it a setting I can change to allow the PSAP to see
> individual DIDs?
>
>
>
> CUCM 7.02
>
> 2851 MGCP
>
> NM-4VWIC-MBRB / VWIC2-1MFT-T1E1-T1
>
>
>
>
>
>
>
> Thanks,
>
>
>
> John
>
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091030/21d0d3ad/attachment.html>