[cisco-voip] ATA187 in CUCM 8.0(2)

[Brian Schultz]

Got it fixed after working with TAC.  Had to first reboot the Publisher,
then reboot the ATA and it registered.  Something with that QED file didn't
take effect until rebooting the Pub...very strange.  There isn't any bug ID
for this...

Brian


On Wed, Dec 8, 2010 at 4:57 PM, Brian Schultz <bms314 at gmail.com> wrote:

> I guess these do have a web interface.  Looks similar to the old 186
> interface, but you just can't change anything.
>
> From the web interface, I can see that all of the network settings are
> correct.  The device information just says 'Registering', it shows the
> firmware load and even the line 1 DN that was assigned in CUCM.  Under
> status messages, it shows that it successfully got its .loads file as well
> as the .cnf.xml file.  But it can't find a CTL file and says 'No CTL
> Installed'.
>
> I don't have any other SIP enabled devices on this system, all phones are
> SCCP.  Is there some SIP configuration needed in CUCM to get the ATA 187 to
> register?
>
> Thanks,
> Brian
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20101215/7118e462/attachment.html>