[cisco-voip] CUE 8.0 with CUCM Issue

[Jorge L. Rodriguez Aguila]

IP2IP GW is on same region and Device Pool as VM CTI Ports, So is Transcoder and They are part of the MRG and MRGL  associated with the Device Pool

From: Ryan Schwab [mailto:schwaby81 at shaw.ca]
Sent: Sunday, April 17, 2011 9:24 PM
To: Jorge L. Rodriguez Aguila; 'Cisco-Voip'
Subject: RE: [cisco-voip] CUE 8.0 with CUCM Issue

Jorge,

This does sound like a transcoding issue. The device that does not support a codec would need to request a transcoder resource. In this case, that's the CUE.

Your CUE is registered via CTI Ports to CUCM? Is the SIP/T1 gateway in a different region than the CTI Ports/Route point?

Where do you have your transcoding resources registered too? If remember correctly the way to do this is to register your transcoder resources in the same fashion you would if it was a CME.


From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jorge L. Rodriguez Aguila
Sent: April-17-11 6:39 PM
To: Cisco-Voip (cisco-voip at puck.nether.net)
Subject: [cisco-voip] CUE 8.0 with CUCM Issue

I have integrated a CUE 8.0 with CUCM 8.0.3 and internally it works perfectly but when calls coming in from a T1 or a SIP trunk are transferred to CUE I get Busy tone on T1 and dropped call on the SIP trunk(IP2IP GW running SIP towards Provider and H323 towards Call Manager). I have verified that even though I am running G711u I have HW transcoding resources available. Any ideas on what Might be? This is my first CUE to Call Manager (non express) I don't seem to find what is wrong and some pointers into where to look are greatly appreciated.


Jorge Rodriguez
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110417/65731704/attachment.html>