[cisco-voip] ISDN T1 voice calls hardware validation

[PF]

Hi

I have tried several configurations

Here is the relevent par of the actual config

version 15.3
boot system flash bootflash:asr1000rp2-adventerprisek9.03.10.07.S.153-3.S7-ext.bin
!
card type t1 0 2
!
multilink bundle-name authenticated
isdn switch-type primary-5ess
!
voice-card 0/0
!
voice service pots
 supported-language FR
!
voice service voip
 clid network-provided
 allow-connections h323 to sip
 allow-connections sip to h323
 allow-connections sip to sip
 signaling forward unconditional
 sip
  bind control source-interface GigabitEthernet1/2/0
  bind media source-interface GigabitEthernet1/2/0
  ds0-num
  header-passing
  privacy id
  outbound-proxy ipv4:172.16.x.y
!
voice class codec 1
 codec preference 1 g711ulaw
!
controller T1 0/2/0
 framing esf
 clock source internal
 linecode b8zs
 cablelength long 0db
 pri-group timeslots 1-24
!
interface Service-Engine0/0/0
!
interface Serial0/2/0:23
 encapsulation hdlc
 isdn switch-type primary-5ess
 isdn negotiate-bchan
!
map-class dialer DOVtest
 dialer voice-call
!
dspfarm profile 1 transcode universal  
 rsvp
 shutdown
!
dial-peer voice 1 voip
 destination-pattern *.
 signaling forward unconditional
 session protocol sipv2
 session target sip-server
 voice-class codec 1  
!
dial-peer voice 2 pots
 destination-pattern xxxxxxx
 incoming called-number xxxxxxx
 direct-inward-dial
!
!
sip-ua 
 credentials username asr1006 password 7 xxxxxxxx realm yyyyy
 retry invite 3
 retry bye 3
 retry cancel 3
 timers trying 1000
 timers register 100
 sip-server ipv4:172.16.x.y
!
!
Pat


  ----- Original Message ----- 
  From: Ryan Huff 
  To: Patrick Fortin 
  Cc: cisco-voip at puck.nether.net 
  Sent: Friday, May 04, 2018 11:43 AM
  Subject: Re: [cisco-voip] ISDN T1 voice calls hardware validation


  I assume you have the card type specified and controller interface configured with timeslots? 


  Can you send the running-config and code version?


  Sent from my iPhone

  On May 4, 2018, at 11:35, Patrick Fortin <pfortin at royaume.com> wrote:


    Hi

    I get this error

     **ERROR**: call_incoming: Received a call id 0x2F with a bad bearercap from xxxxxxxxxx on b channel 1

    seems like the dsp are not associated with the t1 card

    in the config we don't have acces to the following :
    isdn incoming-voice voice
    which should go on the Serial interface. 

    we also don't have the "port" command that should go in the dial-peer voice section

    any ideas ?

    Thanks

    Pat
      ----- Original Message ----- 
      From: Ryan Huff 
      To: PF 
      Cc: cisco-voip at puck.nether.net 
      Sent: Friday, May 04, 2018 11:11 AM
      Subject: Re: [cisco-voip] ISDN T1 voice calls hardware validation


      That correct! I misread! Yeah the shared port adapter T1 should work.  



      Sent from my iPhone

      On May 4, 2018, at 10:36, PF <pucknether at foril.com> wrote:


        Hi

        Thanks for your help

        But there are no NIM slot in the ASR1006 chassis

        NIM is for ASR1001-X I think

        Pat

          ----- Original Message ----- 
          From: Ryan Huff 
          To: PF 
          Cc: cisco-voip at puck.nether.net 
          Sent: Friday, May 04, 2018 9:56 AM
          Subject: Re: [cisco-voip] ISDN T1 voice calls hardware validation


          For isdn voice you’ll need a NIM-8MFT-T1/E1


          Sent from my iPhone

          On May 4, 2018, at 09:31, PF <pucknether at foril.com> wrote:


            Hi
            Can someone help us validate if we can use this hardware to receive voice calls from a isdn T1 (23B+D) and send them in SIP to a softswitch and vice-versa

            ASR1006
            SPA-8XCHT1/E1
            SPA-DSP
            ASR1000-RP2
            ASR1000-ESP40

            in short can it be used to build a voip gateway like an audiocode mediant or a patton smartnode

            Thanks

            Pat

            _______________________________________________
            cisco-voip mailing list
            cisco-voip at puck.nether.net
            https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20180504/4029b1b3/attachment.html>